Assigning a Pendant to a Resident

Follow the steps below when assigning a pendant to a resident at your community.

Note in order to assign a resident pendant the user must have the following permissions;

1. In the Management Group 
2. Set as a Management Admin in the group settings

Assigning a Pendant to a Resident

1. Tap on the Button Management shortcut found on the Today tab
2. Find and select the resident from the list. (*note, the resident profile must be created in Sage before assigning a button)
3. From the resident's button management screen, find and tap on the Assign Button button at the bottom of the page.
4. With the physical Sage button in your hand, press the button once.
5. After a few short moments you should see a new button appear on the Assign Button screen.
6. Tap on the newly displayed button that has appeared and then tap Select at the bottom of the screen.
7. Confirm the details of the button assignment on the next screen. Noting the resident's full name and care type.
8. Tap Assign Button when you are ready to proceed.
9. Once completed, you will see a Button assigned successfully banner appear on the screen.

Once assigned, we recommend testing the button to confirm it is setup properly and working as expected.

Unassigning a Resident Pendant

1. Tap on the Button Management shortcut found on the Today tab
2. Select the Residents section from the top of the page
3. Find and tap on the resident you wish to unassign a button from
4. Tap on the button you wish to unassign.
5. Tap Unassign Resident Pendant at the bottom of the screen.
6. Confirm by tapping Unassign Resident Pendant in the pop-up.
7. Once completed, you will see a Resident Pendant unassigned successfully banner appear at the top of the screen.

Updated March 19, 2025 14:39